Switchcraft Jacks Switches Belton Sockets IEC Inlet Fuse Holders Knobs Soldano SLO
Switchcraft Jacks Switches Belton Sockets IEC Inlet Fuse Holders Knobs Soldano SLO
 
     
 
 
 

 

    Pay by Credit Card or PayPal on Checkout

Individual Parts to Dress your SLO Chassis





 

click to enlarge

 Lamp Assembly - Power Indicator Light   - (requires jewel)
 Fender style lamp assembly that is used in Soldano Products as well as Mesa Bogner, Fender and various other Boutique Amps.
11/16" - (17.463 mm) Chassis Hole

 

 

click to enlarge

 Jewel - For above Lamp Assembly
 Fender style jewels that are used in Soldano Products as well as Mesa Bogner, Fender and various other Boutique Amps.
 Soldano uses Blue. Fenders are typically Red.   (Blue, Red, Green, Yellow, Violet, Peach and Pearl)
 

click to enlarge

 Carling Switch for Power On/Off & Standby
 SPST Switch: Two required for the SLO in the Standby and On/Off positions. (6A @ 125V and 3A @250V)
 

 

 

 

click to enlarge

 
 Correct Knobs for SLO - Front Panel, Rear Impedance and Slave Level

 Exact match knobs for the Soldano SLO100. Deep graphite in color including the dove grey caps as shown. These are a collet style knob with  solid brass internals that firmly grip the entire pot shaft. They are far higher quality than any set screw knob on the market including Marshall  knobs and the standard chicken head pointers.

 

 Front Panel & Impedance Knob - (10 total required):  $4.25 ea.

 

 Slave Level Knob - single (1 required):  $4.25 ea.